It's real easy to pinch a wire when working in the dash area. If not a short that blows a fuse, a wire may have gotten cut clean through. Peugeot 206 indicator not working properly. 5. Dash Lights and Headlight Angle Adjust Stop Working. 2. Peugeot 206 suspected heater matrix leak. 0. Peugeot 307 2006 model 35000 miles on the clock. 1
The information is given by an audible signal accompanied by a message on the multifunction display or by the service indicator light. To change the battery, unclip the casing using a coin at the notch (CR 1620/3 volt battery). If the remote control does not work after the battery has been changed, re-program the remote control.
To reboot you need to press and hold the phone toggle switch for 8 seconds. That 5 minutes might just wake the system from a sleep stake. You should update the NAC system/firmware, that black screen problem is in many TSB. 3008 (P84, 2017) GT Line 1.6 BlueHDi Manual (Nimbus grey)
the hole is located under the starter motor on the front of the block. insert the 5mm allen key and get someone to turn the crank pully clockwise until allen key engages into the fly wheel. the hole in the cam should be at about 25 past. (if it is at 10 to then you neet to remove the pin from the fly wheel and turn the crank 1 full turn)
Turn on the side lights. Switch the engine on and check how the system functions. Press the lock button on the key and keep it pressed for 10 seconds. Turn the engine on again and complete system inspection. If the reboot has been successful the wipers should now work.
. 150 199 166 628 57 28 17 685
peugeot 307 display not working
